Hitachi G200 - Restoring a NAS Module

8. On the NAS module, connect the cable to the same port to which the
cable was connected before replacing cache memory. Be sure the cable
clicks into place.
Related tasks
•
EVS migration after servicing nodes on page 102
Restoring a NAS module
Procedure
1. Click Restore.
2. When the completion message appears, click Close.
3. Click the CHBs tab, and then confirm that the NAS module is Normal.
4. After completing the work, log out and close the Maintenance Utility
window.
5. Migrate the EVS manually from the operating NAS module to the other
NAS module.
Related tasks
•
EVS migration after servicing nodes on page 102
• EVS migration after servicing nodes on page 102
204 Replacing cache memory
Service Guide for VSP Gx00 and VSP Fx00 Models