Removing the front bezel from a dense intermix drive tray
To prevent the rack from tipping when removing a dense intermix drive tray:
• Do not remove multiple dense intermix drive trays simultaneously.
• After removing the dense intermix drive tray, do not place objects on it or
use it as a work space.
Procedure
1. Use the provided key to unlock the bezel.
2. Holding the lower right part of the bezel, gently pull the key toward you
and disengage the right side of the bezel from the ball catch.
Note: To avoid damaging the bezel, do not open the bezel more
than 45 degrees when disengaging the front bezel.
3. Disengage the front bezel from the left tabs, and then remove the bezel.
Removing cables
Observe the following instructions when removing cables form the storage
system.
94 Replacing storage system components
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
