Hitachi G200 - Blocking an ENC

Blocking an ENC
Procedure
1. Start the maintenance utility.
2. Click Hardware > Drive Box.
3. In the Drive Box window, click the ENCs tab.
4. To display the most recent status of the ENC, click Refresh.
5.
Confirm that the status of the ENC to be replaced is Warning.
6. Click the ENC to be replaced, and then click Replace.
7. When the Replace ENC window opens, confirm that the ENC shown in
the window is the one to be replaced.
230 Replacing an ENC
Service Guide for VSP Gx00 and VSP Fx00 Models