5. Align the notch on the cache memory board with the projection inside
the slot.
6. Holding both ends of the cache memory, insert it into the socket.
7. Confirm that the lever is securing the cache memory.
8. To install the DIMM cover, slide it in the direction of the arrow. Confirm
that the DIMM cover is secured by the two hooks on either side.
Next steps
• Install the controller.
• Use the maintenance utility to restore (unblock) the controller.
Removing and installing a front end module
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Use the maintenance utility to block the controller.
• Remove the controller.
Procedure
1. Loosen the two blue screws that secure the front end module.
2. Using the blue screw, pull out the front end module in a straight direction
and remove.
168 Replacing a controller
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
