4. With the lever opened completely, insert the CFM into the slot.
5. Push the CFM all the way into the slot.
6. Close the lever completely.
7. Tighten the blue screw to secure the CFM.
Next steps
• Once all parts are installed on the controller, install it in the storage
system.
• Use the maintenance utility to restore (unblock) the controller.
Removing and installing the backup module
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• The controller must be removed from the storage system.
Procedure
1. Loosen the blue screw that secures the backup module.
2. Open the lever, and then use both hands to remove the backup module.
3. With the backup module lever opened, insert the backup module into the
slot of the new controller.
4. Close the backup module lever and tighten the blue screw.
170 Replacing a controller
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
