Replacing a front end module on a controller
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Use the maintenance utility to block the front end module.
• Confirm that the storage system power is turned on.
• The red STATUS LED is on at the front end module to be replaced.
• Add the front end module to the same locations of controller 1 and
controller 2.
Procedure
1. Disconnect the cable from the front end module.
2. Loosen the two blue screws that secure the front end module.
3. Hold the blue screws, and then gently remove the front end module.
Keep the front end module straight to avoid jostling the components
above and below it.
4. If applicable, remove the SFPs from the failed component and insert the
SFPs into the replacement FED.
208 Replacing a front end module
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
