a. Pull the SFP lever down toward you and pull out the SFP. If you cannot
remove the SFP, pull it out while pushing open the lever toward you.
b. Check the SFP insertion direction and insert the SFP into the port until
it clicks.
5. Orient the new front end module as shown below.
Replacing the front end module on a VSP G200
Replacing the front end module on a VSP G400, G600, G800
6. Insert the new front end module into the slot, just before the "shield
finger."
Replacing a front end module 209
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
