Hitachi G200 - Removing the Front Bezel from a CBLM CBLH Controller

2. Holding the lower right part of the bezel, gently pull the key toward you
and disengage the right side of the bezel from the ball catch.
Note: To avoid damaging the bezel, do not open the bezel more
than 45 degrees when disengaging the front bezel.
3. Disengage the front bezel from the left tabs, and then remove the bezel.
Removing the front bezel from a CBLM CBLH controller
Procedure
1. Use the provided key to unlock the bezel.
2. Holding the lower right part of the bezel, gently pull the key toward you
and disengage the right side of the bezel from the ball catch.
Note: To avoid damaging the bezel, do not open the bezel more
than 45 degrees when disengaging the front bezel.
Replacing storage system components 91
Service Guide for VSP Gx00 and VSP Fx00 Models