Replacing the BKMF backup module
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Confirm that the storage system power is turned on.
• Confirm that the red STATUS LED on the backup module to be replaced is
on.
• Use the Dump tool to collect the storage system configuration information.
• Use the maintenance utility to verify the backup module status.
Procedure
1. Loosen the blue screw that secures the backup module.
2. Open the lever forward.
3. Open the lever.
4. Hold the backup module with both hands, and then pull it out and
remove it.
5. Hold the latch of the cable connector of the battery to be installed in the
backup module and remove the connector from the socket.
6. Remove all batteries that are installed.
A maximum of two batteries can be installed.
7. Loosen the blue screw on the rear side of the new backup module.
8. Slide the top panel of the new backup module and remove it.
9. In the new backup module, install all batteries you removed and route
the cables along the groove of the backup module.
If you removed one battery, install the battery in the front (fan side) of
the storage system. Route the cables to avoid bending the cables.
10. Connect the cable connector to the socket.
11. Slide the top panel of the backup module and attach it.
12. Tighten the blue screw on the rear panel of the backup module.
13. With the lever of the backup module opened forward, insert the new
backup module into the slot.
Replacing a backup module 273
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
