IP address configuration for the host
Use Hitachi Device Manager - Storage Navigator to set the IP address, subnet
mask, and default gateway that the host can use to communicate with the
storage system.
TCP/UDP port filtering being performed on the network switch
The default TCP port number for Hitachi Device Manager - Storage Navigator
is 2000.
Set an appropriate value for the network environment of the customer.
[default port number]: 2000 (standard)
28355 (secure)
Change the port number in network environments using Cisco SIP phones.
Searching storage system across IPv6 routers
The Auto Search Storage system of IPv6 uses link-local scope multicast.
The IPv6 router is unable to transfer this multicast to other local links, so the
IPv6 router cannot search storage systems across the IPv6 router. The Auto
Search Storage system of IPv6 uses link-local scope multicast. The IPv6
router cannot transfer this multicast to other local links, so the IPv6 router is
unable to search storage systems across the IPv6 router. For different local
links, register the storage system using a static IP address search.
Checking hardware replacement alerts
The Maintenance Utility window displays alerts when hardware components
need to be replaced.
Procedure
1. In the Maintenance Utility window, click Hardware > Target
Hardware.
2. Click the Status link for the hardware.
3. Open the Related Alerts window for the appropriate hardware
components, as listed in the following tables.
VSP G200 part
Main window Tab Status link
Controller chassis Controller Chassis
window
Drives Status
CTLs CTL Status
Fan Status
CHBs Status
SFP Status
1
Troubleshooting the storage system 315
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
