Hitachi G200 - Replacing a Controller for a CBSS or CBSL Controller; Removing the Controller

Note: Do not click Restore at this time.
Replacing a controller for a CBSS or CBSL controller
When you replace a CBSS or CBSL controller, you will have to install the
following components on the new controller:
• Fan
• Cache memory
• Front end module
• Cache flash memory
• Backup module
Removing the controller
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Use the maintenance utility to block the controller.
• Confirm that the storage system power is turned on.
• Confirm that the red CTL ALARM LED for the controller to be replaced is on.
Procedure
1. Remove all cables connected to the controller.
2. Loosen the blue screw that secures the controller, and then open the
lever.
164 Replacing a controller
Service Guide for VSP Gx00 and VSP Fx00 Models