Hitachi G200 - Blocking a Pcie Cable Connector

Blocking a PCIe cable connector
Before you begin
• Confirm that the storage system power is turned on.
• Use the Dump tool to collect the storage system configuration information.
• The red STATUS LED is on at the PCIe cable connector to be replaced.
Procedure
1. Start the maintenance utility.
2. Click Hardware > Channel Board Box.
3. Click the PCPs tab.
4. To display the most recent status of the PCIe cable connector click
Refresh.
5. Confirm that the status of the PCIe cable connector to be replaced
isWarning.
6. Select the PCIe cable connector to be replaced, and click Replace.
7. Click Block.
292 Replacing a PCIe cable connector
Service Guide for VSP Gx00 and VSP Fx00 Models