Hitachi G200 - Replacing the ENC for SFF and LFF Drive Trays

Replacing the ENC for SFF and LFF drive trays
Do not touch the ENC connector because it is fragile. Check that the ENC
connector is in good shape and is not deformed, damaged, or dusty before
installing the ENC.
Note: Be sure to replace the faulty ENC. If you replace the operational ENC,
the system will go down.
Caution: A short-circuit can cause a fire. Never insert metal or other objects
into the cable connector; otherwise, a short-circuit can occur.
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Confirm that the storage system power is turned on.
• Use the maintenance utility to block the ENC.
• Confirm that the red ALARM LED for the ENC to be replaced is on.
232 Replacing an ENC
Service Guide for VSP Gx00 and VSP Fx00 Models