Procedure
1. Disconnect the SAS cable from the ENC to be replaced.
2. Open toward you the right and left levers that secure the ENC.
When the levers are completely opened, the ENC moves forward.
3. Hold the ENC with both hands, and then pull it gently and remove it.
4. Open completely the right and left levers of the new ENC.
5. Insert the ENC into the slot, and then push the right and left levers
toward the ENC until the levers open slightly.
6. Confirm that the red ALARM LED on the new ENC is off.
7. Connect the SAS cable to the new ENC.
Replacing the ENC for a FMD drive tray
Do not touch the ENC connector because it is fragile. Check that the ENC
connector is in good shape and is not deformed, damaged, or dusty before
installing the ENC.
Note: Be sure to replace the faulty ENC. If you replace the operational ENC,
the system will go down.
Caution: A short-circuit can cause a fire. Never insert metal or other objects
into the cable connector; otherwise, a short-circuit can occur.
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• Confirm that the storage system power is turned on.
Replacing an ENC 233
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
