Hitachi G200 - Blocking a NAS Module

Blocking a NAS module
Before you begin
• Confirm that the storage system power is turned on.
• Use the Dump tool to collect the storage system configuration information.
• The red STATUS LED is on at the NAS module to be replaced.
Procedure
1. Start the maintenance utility.
2. Click Hardware > Controller Chassis.
3. Click the CHBs tab.
4. To display the most recent status of the PCIe module, click Refresh.
5. Check that the status of the failed NAS module is Warning.
6. Click the NAS module where the failure occurred, and then click
Replace.
7. Click Block.
304 Replacing a NAS module
Service Guide for VSP Gx00 and VSP Fx00 Models