Hitachi G200 - Removing the Front Bezel from the SVP

Procedure
1. Use the provided key to unlock the front bezel.
2. Hold the key and bottom of the bezel with both hands while facing the
front bezel.
3. Insert the tabs on the left-front side of the SVP into the tab holes on the
front bezel.
4. Push the right side of the bezel to engage it with the ball catch on the
front of the SVP to secure the bezel.
5. Use the provided key to lock the front bezel. To avoid damaging the key,
verify the key is fully inserted into the lock before turning it.
Removing the front bezel from the SVP
Procedure
1. Use the provided key to unlock the bezel.
2. Holding the lower right part of the bezel, gently pull the key toward you
and disengage the right side of the bezel from the ball catch
Replacing storage system components 89
Service Guide for VSP Gx00 and VSP Fx00 Models