Hitachi G200 - Restoring a Pcie Module

5. Gently push the front of the PCIe module until the module is inserted all
the way into the slot.
6. Tighten the two blue screws to secure the PCIe module.
7. Connect the cable to the new PCIe module.
8. Check that the red STATUS LED on the PCIe module is off.
Restoring a PCIe module
Procedure
1. At the Replace PCIe Channel Board window, click Restore.
2. When the completion message appears, click Close.
3. Click the PECBs tab and confirm that the status of the new PCIe module
is Normal. If necessary, click Refresh at the top-right of the window to
update the status of the window.
4. Log out and close the Maintenance Utility window.
Replacing a PCIe module 283
Service Guide for VSP Gx00 and VSP Fx00 Models