Number
Description
1
Power socket. Attach the power cable supplied
with the SVP.
2
Four LAN ports arranged as follows:
LAN3 LAN4
LAN1 LAN2
These ports connect to your IP network, the
management console PC, and the user LAN port
on each storage system controller.
Note: After the Initial Startup Wizard is run, the SVP can be used in non-
bridge mode. In this mode, the cables can be removed from SVP ports LAN3
and LAN4 and attached to switches. For more information, contact customer
support.
76 Hardware description
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
