Honeywell Series 8 I/O - 5.6 Configuring the Main tab - IOM block

5. Series 8 I/O Configuration Form Reference
5.6. Configuring the Main tab - IOM block
110 Series 8 I/O User's Guide R500
Honeywell April 2017
 Create hardware blocks
 Associate blocks
 Assign modules
 Assign devices, and
 Load components.
Regardless of what tool is used to configure Series 8 I/O, the IOM must be present during
configuration load. If the IOM is not present load errors occurs and a subsequent reload
or checkpoint restore is required.
Refer to the Control Building User’s Guide to create control strategies.
5.6 Configuring the Main tab - IOM block
Configuring modules - Main tab
The following configuration information pertains to the Main tab for all Series 8 module
types.
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
 Redundancy is determined by checking the, This IOM is redundant checkbox.
 All illustrations used in the procedure are for example purposes only.
The following is an example of a DIGITAL OUTPUT 24VDC Block, Configuration
form - Main tab.