Honeywell Series 8 I/O - 5.22 Configuring HART Notifications Tab - Channel Block; Configuring Modules - Identification Tab

5. Series 8 I/O Configuration Form Reference
5.22. Configuring HART Notifications tab - Channel block
R500 Series 8 I/O User's Guide 151
April 2017 Honeywell
5.22 Configuring HART Notifications tab - Channel block
Configuring modules - Identification tab
The following configuration information pertains to the Identification tab for all Series 8
I/O Analog Input and Analog Output modules.
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
 All illustrations used in the procedure are for example purposes only.
The following is an example of an Analog Output Channel Block, Configuration form -
HART Notifications tab.