Honeywell Series 8 I/O - 5.14 Configuring Identification Tab - IOM Block; Configuring Modules - Identification Tab

5. Series 8 I/O Configuration Form Reference
5.14. Configuring Identification tab - IOM block
R500 Series 8 I/O User's Guide 131
April 2017 Honeywell
5.14 Configuring Identification tab - IOM block
Configuring modules - Identification tab
The following configuration information pertains to the Identification tab for all Series 8
I/O modules.
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
 All illustrations used in the procedure are for example purposes only.
The following is an example of a DIGITAL OUTPUT 24VDC Block, Configuration
form - Identification tab.