Honeywell Series 8 I/O - 13.4 Getting Further Assistance; Other Troubleshooting Sources; Guidelines for Requesting Support

13. Series 8 I/O Alarms and Failures
13.4. Getting further assistance
R500 Series 8 I/O User's Guide 291
April 2017 Honeywell
Code
Name
Cause/description
Anal
og
Inpu
t
Anal
og
Out
put
Digit
al
Inpu
t
Digit
al
Out
put
TC/RTD
35
IOMUSER
RESET
User triggered reset
X
X
X
X
X
13.4 Getting further assistance
Other troubleshooting sources
The following table lists other documents and sections that contain troubleshooting
information for other Experion subsystems.
Document/Section
Comments
Control Builder Error Codes Reference
Describes error codes generated from within
Control Builder.
Server Scripting Reference > Server scripting
error messages
Describes the meaning of error messages in
the server log specific to server scripting.
Guidelines for requesting support
If you cannot resolve a problem by using this guide, you can request support from your
Honeywell TAC. When requesting support, please supply as many relevant details about
the problem by referring to Gathering information for reporting problems to Honeywell
to obtain the problem-related information.