Honeywell Series 8 I/O - Figure 38 Control Confirmation Tab

5. Series 8 I/O Configuration Form Reference
5.14. Configuring Identification tab - IOM block
130 Series 8 I/O User's Guide R500
Honeywell April 2017
Figure 38 Control Confirmation tab
To configure the Control Confirmation tab, perform the following steps.
Step
Action
1
Under the Control Confirmation tab, select or clear the Control Confirmation
check box. If necessary, press F1 to access online help for assistance during
this step.
2
Proceed to the following procedures to configure parameters on the
remaining tabs for I/O Module, or click OK to accept only the changes made
so far and return to the Project tree.