Honeywell Series 8 I/O - Using the drag and drop method; 6.2 Assigning an IOM to an IOLINK in the Project tab; Using the Assignment dialog box

6. Series 8 I/O Configuration
6.2. Assigning an IOM to an IOLINK in the Project tab
R500 Series 8 I/O User's Guide 159
April 2017 Honeywell
Using the drag and drop method
To add an IOM to the Project tab by the drag and drop method, perform the following
steps.
Step
Action
1
Drag an IOM icon from the Library tab to an open area on the Project tab.
Name New Function Block(s) dialog box appears.
2
Accept or type a new tagname in the Destination column.
3
Click Finish. The IOM is displayed in the Project tab.
TIP
IOM names can be up to 16 characters long.
6.2 Assigning an IOM to an IOLINK in the Project tab
Using the Assignment dialog box
To assign an IOM to an IOLINK function block using the Assignment dialog box,
perform the following steps.
Step
Action
1
Click the Assign button in the toolbar. The Execution Environment
Assignment dialog box appears.