5. Series 8 I/O Configuration Form Reference
5.13. Configuring Control Confirmation tab - IOM block
R500 Series 8 I/O User's Guide 129
April 2017 Honeywell
5.13 Configuring Control Confirmation tab - IOM block
Configuring modules - Control Confirmation tab
The Control Confirmation tab is common to all configuration forms for tagged blocks in
Control Builder.
When this block is loaded to a controller,
you can view the control confirmation configuration for this tagged object in Station
and also make changes to it.
If you make changes through Station, you must initiate an Upload or Upload
with Contents function through the Controller menu in Control Builder for the
object in the Monitoring tab to synchronize changes in the Engineering
Repository Database (ERDB).
The following configuration information pertains to the Control Confirmation tab for all
Series 8I/O modules.
Prerequisites
Control Builder is running
A Series 8 I/O control module was created
Considerations
Control Confirmation is enabled by checking the Control Confirmation checkbox.
All illustrations used in the procedure are for example purposes only.
The following is an example of a DIGITAL OUTPUT 24VDC Block, Configuration
form - Control Confirmation tab.
To Next Page
Loading...
