11. Series 8 I/O Maintenance
11.1. Series 8 recommended spares
258 Series 8 I/O User's Guide R500
Honeywell April 2017
11. Series 8 I/O Maintenance
11.1 Series 8 recommended spares
The following table provides replacement parts, or parts that you may want to keep on
hand for backup.
IOM removal and installation under power
The IOM has been designed to permit removal and installation under power (RIUP)
without damaging the module or interrupting IOTA communications. Notice should be
taken on how this may impact the active process.
CAUTION
We recommend that you proceed with extreme caution whenever replacing
any component in a control system. Ensure the system is offline or in a safe
operating mode.
Component replacements may also require corresponding changes in the
control strategy configuration through Control Builder, as well as downloading
appropriate data to the replaced component.
Refer to Replacing an I/O module for IOM replacement and cautionary information.
Table 65 Recommended spare parts
To Next Page
Loading...
