Honeywell Series 8 I/O - 5.19 Configuring HART Device Status Tab - Channel Block; Configuring Modules - Identification Tab

5. Series 8 I/O Configuration Form Reference
5.19. Configuring HART Device Status tab - Channel block
144 Series 8 I/O User's Guide R500
Honeywell April 2017
5.19 Configuring HART Device Status tab - Channel block
Configuring modules - Identification tab
The following configuration information pertains to the Identification tab for all Series 8
I/O modules.
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
 All illustrations used in the procedure are for example purposes only.
The following is an example of an Analog Input Channel Block, Configuration form -
HART Device Status tab.