Honeywell Series 8 I/O - Table 16 Jumpers to Support Analog Input Connections

4. Series 8 IOTA Pinouts
4.2. Differential Analog input IOTA (Models 8X-TAIDA1 and 8X-TAIDB1)
70 Series 8 I/O User's Guide R500
Honeywell April 2017
3
14
JP42 - JP44
JP43 - JP44
4
13
JP39 - JP41
JP40 - JP41
5
12
JP36 - JP38
JP37 - JP38
6
11
JP33 - JP35
JP34 - JP35
7
10
JP30 - JP32
JP31-JP32
8
9
JP27 - JP29
JP28 - JP29
9
8
JP64 - JP68
JP65 - JP68
10
7
JP62 - JP67
JP63 - JP67
11
6
JP60 - JP66
JP61 - JP66
12
5
JP57 - JP59
JP58 - JP59
13
4
JP54 - JP56
JP55 - JP56
14
3
JP51 - JP53
JP52 - JP53
15
2
JP24 - JP26
JP25 - P26
16
1
JP21 - JP23
JP22 - JP23
ATTENTION
 Three pin jumper designations are different for 9 inch and 12 inch IOTAs.
 By default, all channels available in these IOTAs are configured for
differential mode. If a shorting jumper is not present, then that channel is
configured in differential mode. If you want to modify the configuration
from differential mode to single-ended mode, shorten the pair of jumpers.
Jumper Settings
Jumpers are utilized to support the following conditions.
Table 16 Jumpers to support Analog Input connections
Channels
Signal screw
For channels
1 through 16
Contains the following:
 A corresponding jumper. Therefore, the jumper for channel 1 is JP1,
and so on.