Honeywell Series 8 I/O - Page 71

4. Series 8 IOTA Pinouts
4.2. Differential Analog input IOTA (Models 8X-TAIDA1 and 8X-TAIDB1)
R500 Series 8 I/O User's Guide 71
April 2017 Honeywell
Channels
Signal screw
 The jumper must be cut if the voltage transmitters (1-5V) are connected
to the channel.
For channel1
through16 non-
redundant 9 inch
IOTA
Contains the following:
 A corresponding jumper. Therefore, the jumper for channel 1 is JP1,
and so on.
 The jumper must be cut if the voltage transmitters (1-5V) are connected
to the channel.