Honeywell Series 8 I/O - 5.16 Configuring HART Status Tab - IOM Block; Configuring Modules HART - Status Tab

5. Series 8 I/O Configuration Form Reference
5.16. Configuring HART Status tab - IOM block
R500 Series 8 I/O User's Guide 137
April 2017 Honeywell
5.16 Configuring HART Status tab - IOM block
Configuring modules HART - Status tab
The following configuration information pertains to the HART Status tab for the
following modules:
 ANALOG INPUT WITH HART
 ANALOG OUTPUT WITH HART
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
Note: No user-defined configuration setting on the HART Status tab and there are no
configuration items in HART status tab.
 All illustrations used in the procedure are for example purposes only.
The following is an example of an ANALOG INPUT WITH HART Block,
Configuration form - HART Status tab.