Honeywell Series 8 I/O - 7. Series 8 I;O Operations

R500 Series 8 I/O User's Guide 205
April 2017 Honeywell
7. Series 8 I/O Operations
7.1 Overview
The following section describes the typical activities that you may be required to perform
during normal operations while using Control Builder.
7.2 Reviewing the Control Builder icons
Series 8 I/O block icons
After loading the containing Control Module, the I/O channel block icon appears in the
Control Builder monitoring tree. It exists under the containing Control Module and under
the assigned IOM block. In the case of redundancy, a secondary IOM is visible in the
monitoring tree.
TIP
The icon's appearance is based on the ICONSTATE parameter.
Table 55 Channel block icons
If icon is . . .
Then, it represents . . .
COMM error or CONFIG mismatch error - Primary State
red
Non-redundant
both red
No primary or secondary
front red
back yellow
No primary, secondary not synched
RUN - Primary State
green
Non-redundant