Honeywell Series 8 I/O - 5.21 Configuring HART Variables Tab - Channel Block; Configuring Modules - Identification Tab

5. Series 8 I/O Configuration Form Reference
5.21. Configuring HART Variables tab - Channel block
148 Series 8 I/O User's Guide R500
Honeywell April 2017
Plain text
Parameter name
User configurable
Revision
HDVRREVCD
No
Id (Serial number)
HDEVIDCD
No
Installed device
Manufacturer
HDEVMFG
No
Type
HDEVTYP
No
Type (Name)
HDEVTYPNAME
No
Revision
HDEVRREV
No
Id (Serial number)
HDVID
No
Device Type Mismatch
HDEVMISM
No
Device Revision Mismatch
HREVMISM
No
Device ID Mismatch
HDEVIDFL
No
Accept Device ID
ACCEPTDEV
No
Supported HART Version
HARTVERSION
No
Universal Command Revision
HUCMREV
No
Software Revision
HSWREV
No
Hardware Revision
HHWREV
No
5.21 Configuring HART Variables tab - Channel block
Configuring modules - Identification tab
The following configuration information pertains to the Identification tab for all Series 8
I/O Analog Input or Analog Output modules.
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
 All illustrations used in the procedure are for example purposes only.