Honeywell Series 8 I/O - 8.3 Loading the IOM block the first time; Loading the IOM block present on the IOLINK; Loading IOM

8. Series 8 I/O Loading
8.3. Loading the IOM block the first time
R500 Series 8 I/O User's Guide 229
April 2017 Honeywell
Figure 62 Loading the IOM block the first time
Loading IOM
Use the following general procedure to load an Input/Output Module (IOM). The load
procedure is similar for all I/O signal-handling components.
Prerequisites
 Control Builder is running
 This procedure assumes that I/O Modules are installed and capable of
communicating with the server.
Considerations
 All illustrations used in the procedure are for example purposes only.