Honeywell Series 8 I/O - 6. Series 8 I;O Configuration; 6.1 Adding an IOM to Project; Using the File menu method

R500 Series 8 I/O User's Guide 157
April 2017 Honeywell
6. Series 8 I/O Configuration
6.1 Adding an IOM to Project
The following IOMs are added to the Project tab using the either the File menu method
or the Drag and Drop method:
 ANALOG INPUT WITH HART - High Level Analog Input, HART Capable, 16
channels
 ANALOG INPUT - High Level Analog Input, 16 channels
 TC/RTD - Low Level Analog Input Mux, 64 channels
 Analog Output - Analog Output, 16 channels
 ANALOG OUTPUT WITH HART - Analog Output, HART Capable, 16 channels
 DIGITAL INPUT 24VDC - Low Voltage (24VDC) Digital Input, 32 channels
 DIGITAL INPUT SEQUENCE OF EVENTS - Digital Input - Sequence of Events,
32 channels
 DIGITAL OUTPUT 24VDC - Bussed Low Voltage Digital Output, 32 channels
 DIGITAL INPUT PULSE ACCUMULATION – Pulse Accumulation, 32 channels
Using the File menu method
To add an IOM to the Project tab by the File menu method, perform the following steps.
Step
Action
1
Click File > New > I/O Modules > Series_8_IO.
A list of the available Series 8 I/O block types is displayed.
2
Select a block types from the drop down list. A Block Parameters
configuration form is displayed.