Honeywell Series 8 I/O - 5.15 Configuring the Calibration tab - IOM block

5. Series 8 I/O Configuration Form Reference
5.15. Configuring the Calibration tab - IOM block
134 Series 8 I/O User's Guide R500
Honeywell April 2017
5.15 Configuring the Calibration tab - IOM block
Configuring modules - Calibration tab
The following configuration information pertains to the Calibration tab for the following
modules:
 ANALOG INPUT WITH HART
 ANALOG INPUT
 TC/RTD
 Analog Output
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
Calibration can only be performed from the Monitoring side.
The Execution State must be set to IDLE before enabling calibration.
 All illustrations used in this procedure are for illustration purposes only.
The following is an example of an ANALOG INPUT WITH HART Block,
Configuration form - Calibration tab.