Honeywell Series 8 I/O - Configuring Box Soft Failures Tab - IOM Block; Configuring Modules - Box Soft Failures Tab

5. Series 8 I/O Configuration Form Reference
5.9. Configuring Box Soft Failures tab - IOM block
118 Series 8 I/O User's Guide R500
Honeywell April 2017
To Reset Statistics on the Maintenance tab, perform the following steps.
Step
Action
1
From the Statistics Partner frame, monitor the CPU Free Average and CPU
Free Minimum settings. To reset statistics to their default values, proceed to
the next step.
2
Click Reset Statistics to reset CPU Free Average and CPU Free Minimum
to their default settings.
5.9 Configuring Box Soft Failures tab - IOM block
Configuring modules - Box Soft Failures tab
The following configuration information pertains to the Box Soft Failures tab for the
following modules:
 Analog Input with HART
 Analog Input
 TC/RTD
 Analog output
 Analog Output-HART
 Digital Input 24VDC
 Digital Input Sequence of Events
 Digital Output-24VDC
 DIGITAL INPUT PULSE ACCUMULATION
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
Note: No user-defined configuration setting on the Box Soft Failures tab.
 All illustrations used in the procedure are for example purposes only.
The following is an example of a DIGITAL OUTPUT 24VDC Block, Configuration
form -
Box Soft Failures tab.