Honeywell Series 8 I/O - 5.10 Configuring Channel Soft Failures Tab - IOM Block; Configuring Modules - Channel Soft Failures Tab

5. Series 8 I/O Configuration Form Reference
5.10. Configuring Channel Soft Failures tab - IOM block
120 Series 8 I/O User's Guide R500
Honeywell April 2017
5.10 Configuring Channel Soft Failures tab - IOM block
Configuring modules - Channel Soft Failures tab
The following configuration information pertains to the Channel Soft Failures tab for the
following modules:
 ANALOG INPUT WITH HART
 ANALOG INPUT
 TC/RTD
 Analog Output
 ANALOG OUTPUT WITH HART
 DIGITAL INPUT 24VDC
 DIGITAL INPUT SEQUENCE OF EVENTS
 DIGITAL OUTPUT 24VDC
 DIGITAL INPUT PULSE ACCUMULATION
Prerequisites
 Control Builder is running
 A Series 8 I/O control module was created
Considerations
Note: No user-defined configuration setting on the Channel Soft Failures tab.
 All illustrations used in the procedure are for example purposes only.
The following is an example of a DIGITAL OUTPUT 24VDC Block, Configuration
form - Channel Soft Failures tab.