Honeywell Series 8 I/O - Page 136

5. Series 8 I/O Configuration Form Reference
5.15. Configuring the Calibration tab - IOM block
136 Series 8 I/O User's Guide R500
Honeywell April 2017
To configure the Calibration Status, perform the following steps.
Step
Action
Prior to modifying the Calibration Status, the Execution State of the IOM must
be set to IDLE.
1
Select either:
 Disabled indicates disabling Calibration
 Enabled indicates enabling Calibration
Not Permitted indicates the Execution State of the IOM is still in the RUN
state, which does not allow you to select Disable or Enable. Changing the
Execution State of the IOM to IDLE allows you to modify the Calibration
Status.
2
Proceed to the following procedures to configure parameters on the
remaining tabs for the module, or click OK to accept only the changes made
so far and return to the Project tree.