Honeywell Series 8 I/O - Page 160

6. Series 8 I/O Configuration
6.2. Assigning an IOM to an IOLINK in the Project tab
160 Series 8 I/O User's Guide R500
Honeywell April 2017
Step
Action
2
Select an IOM module from the Available Modules area.
3
Click Assign. The IOM is loaded to the Assign To: area
4
Click Close to complete the assignment.
TIP
The IOM is assigned to an IOLINK function block in the manner as CM blocks
are assigned to a CEEC300 function block.
You can also drag and drop the IOM from the Project tab to the IOLINK function block.