6. Series 8 I/O Configuration
6.3. Adding an IOC block to a Control Module
164 Series 8 I/O User's Guide R500
Honeywell April 2017
Controller was created, CM was created, IOM was added and assigned to an
IOLINK
Considerations
The Control Module cannot be loaded until all IOC blocks have been assigned to the
IOM blocks.
To add an IOC to a Control Module by dragging and dropping from the Library tab,
perform the following steps.
Drag a Series 8 I/O channel block icon to an open area in a Control Module.
The cursor changes to denote an IOC is captured and available for
placement in to the CM control window.
To Next Page
Loading...
