Honeywell Series 8 I/O - Page 217

7. Series 8 I/O Operations
7.6. Activating HART
R500 Series 8 I/O User's Guide 217
April 2017 Honeywell
 further generation of the HART alarms / events are terminated
Note: Changing this parameter affects only the HART alarm / event behavior and the
LED update of the device status in the HART device status tab occurs as usual regardless
of the state of HALARMENABLE.
To disable HART Alarm and Events, perform the following steps.
Step
Action
1
Double-click the Analog Input or Analog Output channel block. The channel
block configuration form appears.
2
Select the HART Configuration tab from the configuration form.
3
Deselect the Enable HART Alarm and Events (HALARMENABLE parameter).