Appendix C
Utilities
EFI/POSSE Commands
175
Fast initialization: Enabled
System Wake-On-LAN: Disabled
* To display the current device connection policy setting
fs0:\> ioconfig fast_init
Fast initialization: Enabled
* To disable fast initialization
fs0:\> ioconfig fast_init off
Fast initialization: Disabled
* To enable the System Wake-On-LAN setting
fs0:\> ioconfig wol on
System Wake-On-LAN: Enabled
baud
Sets the baud rate and communication settings for a UART.
Syntax
baud <index> <baudrate>
Parameters
<index> 0 through the total number of UARTS minus one
<baudrate> baud rate.
Operation
This command is used to change the speed for a UART in the server. This command works for all UARTs
visible to EFI/POSSE. If the UART is part of processor dependent hardware (PDH) space and is initialized by
the core firmware, this command communicates the settings to core firmware so the UART can be initialized
with the new settings on the next boot. System default is 9600 baud.
Other Communication parameters are listed in Table C-2.
Table C-2 Communications Parameters
Parameter Value
RECEIVE_FIFO_DEPTH 1
TIMEOUT 1000000
PARITY No parity
DATA_BITS 8
STOP_BITS 1
CONTROL_MASK 0
To Next Page
Loading...
Need help?
General