Chapter 3
Powering Off and Powering On the Server
Powering On the Server
44
Step 6. Start the operating system. See Appendix B, “Booting the Operating System,” on page 147, or your
operating system documentation for more information.
Powering On the Server Manually
NOTE If the power restore feature is set to Always On through the iLO MP PR command, the server
may automatically power on to the full power state.
To manually power on the server, follow these steps:
Step 1. Plug all power cables into the receptacles on the rear panel of the server.
Step 2. Press the power button to start the server.
Step 3. Start the operating system. See Appendix B, “Booting the Operating System,” on page 147, or your
operating system documentation for more information.
To Next Page
Loading...
