5. Attach the data (1) and power (2) cables to the SATA drive.
Figure 4-54 Connecting the SATA cables to the SATA drive
6. For a single SATA drive, connect the SATA 0 data cable from the hard drive (1) to the SATA0 port
(2) in the workstation chassis.
For a second SATA drive, connect the SATA 1 data cable from the hard drive to the SATA1 port
in the workstation chassis.
Figure 4-55 Connecting the SATA data cable to the workstation SATA port
NOTE: To install three or four SATA drives, install the third and fourth drives in the workstation optical
bays. See
Installing SATA hard drives in the optical drive bays (optional) on page 102 for instructions.
ENWW Removing and replacing components 101
To Next Page
Loading...
