HP xw4600 - Removing the Hood Sensor; Smart Cover Lock Solenoid (Optional); Removing the Smart Cover Lock Solenoid

Removing the Hood Sensor
To remove the Hood Sensor:
1. Disconnect power from the system (
Predisassembly procedures on page 58) and remove the side
access panel (
Removing the side access panel on page 64).
2. Disconnect the Hood Sensor connector from system board (1).
Figure 4-9 Removing the Hood Sensor
3. Slide the Hood Sensor forward, push it down, and then remove it from the chassis (2).
NOTE: To replace the Hood Sensor, reverse the previous steps.
Smart Cover Lock solenoid (optional)
This section describes how to remove the Smart Cover Lock solenoid
Removing the Smart Cover Lock solenoid
To remove the Smart Cover Lock solenoid:
NOTE: To purchase a FailSafe key, contact your authorized HP reseller or service provider, or visit
the HP Web site for ordering information.
1. Disconnect power from the system (Predisassembly procedures on page 58) and remove the side
access panel (
Removing the side access panel on page 64).
66 Chapter 4 Removal and replacement procedures ENWW