2. Push gently outward on the socket levers (1).
Figure 4-21 Removing a memory module
3. Lift the DIMM straight up and out of the socket. Store the DIMM in an anti static bag (2).
Installing a memory module
This section describes how to install a memory module.
Supported DIMM configurations
The HP xw4600 Workstation supports these memory module configurations:
●
Four DIMM slots
●
Memory configuration from 512 MB to 2 GB
●
Dual-channel DIMMs
Memory module requirements
CAUTION: HP only ships DIMMs that are electrically and thermally compatible with this workstation.
Because third-party DIMMs might not be electrically or thermally compatible, they are not supported by
HP.
NOTE: DIMMs and their sockets are keyed for proper installation. Be sure these guides line up when
installing DIMMs.
Use only industry-standard, unbuffered, PC2–5300E (667 MHz) or PC2–6400E (800 MHz) DIMMs.
If multiple DIMMs are installed in a workstation, they must be installed in pairs of the same size and type
in each channel.
76 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
