EasyManuals Logo

HP xw4600 User Manual

HP xw4600
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
the options purchased.) You can also move CD images to another location, such as a network share,
or to be copied to a DVD or CD at a later time or from another system.
Restoring from HPBR DVDs or CDs
To start the system recovery process, boot from the DVD or CD you created previously, then carefully
follow the online instructions.
Restoring a system directly from the recovery partition
Follow these steps to start the HPBR system restore process from the Recovery Manager:
1. Boot the workstation.
2. When prompted on the boot splash screen to enter the Recovery Manager, press F11 .
3. Follow the prompts to restore the system to factory-like condition.
Ordering backup software
If you are unable to create system recovery CDs or DVDs, you can order a recovery disk set from the
HP support center.
NOTE: Before calling HP to order the software, have your workstation serial number available.
To obtain the support center telephone number for your region:
1. Visit
http://www.hp.com/support/contactHP.
2. Select your region.
3. Under the Call HP heading, select Technical support after you buy.
Protecting your software
To protect your software from loss or damage, keep a backup copy of all system software and related
files stored on the hard drive. For instructions on making backup copies of data files, see the operating
system or backup utility documentation.
HP software
The following HP software might be installed on your workstation, depending on the operating system
and options purchased:
Computer Setup (F10) Utility and diagnostics
HP support software, including device drivers
Security management tools (optional)
Software support management tools
Additional software is available for download:
HP Client Manager Software is available at
http://www.hp.com/go/easydeploy
System Software Manager is available at
http://www.hp.com/go/ssm
22 Chapter 2 Configuring and restoring the operating system ENWW

Table of Contents

Other manuals for HP xw4600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP xw4600 and is the answer not in the manual?

HP xw4600 Specifications

General IconGeneral
Tcase72.4 °C
Bus typeFSB
SteppingE0
Processor cache6 MB
Processor cores2
Processor modelE8400
System bus rate- GT/s
Processor familyIntel® Core™2 Duo
Processor seriesIntel Core 2 Duo E8000 Series
Processor socketLGA 775 (Socket T)
Processor codenameWolfdale
Processing Die size107 mm²
Processor frequency3 GHz
Processor cache typeL2
Processor lithography45 nm
Processor manufacturerIntel
Processor front side bus1333 MHz
Processor operating modes64-bit
ECC supported by processorNo
Thermal Design Power (TDP)65 W
Number of processors installed1
CPU multiplier (bus/core ratio)9
Number of Processing Die Transistors410 M
Audio systemHigh Definition Audio
Product typeWorkstation
Motherboard chipsetIntel® X38 Express
ECCYes
Internal memory2 GB
Memory clock speed800 MHz
Internal memory typeDDR2-SDRAM
Maximum internal memory8 GB
Memory layout (slots x size)2 x 1 GB
HDD speed7200 RPM
HDD capacity250 GB
HDD interfaceSATA
Optical drive typeDVD-RW
Graphics card-
Networking featuresGigabit Ethernet (10/100/1000)
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power supply475 W
Chassis typeTower
Country of originChina
Processor codeSLB9J
Processor ARK ID33910
Processor package size37.5 x 37.5 mm
On-board graphics card modelNot available
Weight and Dimensions IconWeight and Dimensions
Depth456 mm
Width168 mm
Height450 mm
Weight19000 g

Related product manuals