HP xw4600 User Manual

Preparing to configure passwords
The Computer Setup (F10) Utility enables you to create setup and power-on passwords.
When you create a setup password, only the power-on password is required to access the Computer
Setup (F10) Utility and any other information on the workstation. When you create both passwords, only
the setup password gives you access to the Computer Setup (F10) Utility.
When both passwords are created, the setup password can also be used in place of the power-on
password as an override to log into the workstation (a useful feature for a network administrator).
If you forget a password, two methods are available for clearing the password to gain access to the
information on the workstation:
●
Reset the password jumper
●
Press the Clear CMOS button
CAUTION: Pressing the Clear CMOS button resets CMOS values to factory defaults and erases any
customized information, including passwords, asset numbers, and special settings. It is important to
back up your workstation CMOS settings before resetting them in case they are necessary later. To
back up the CMOS settings, run the Computer Setup (F10) Utility and select Save to Diskette from the
File menu.
148 Chapter 7 Configuring password security and resetting CMOS ENWW

HP xw4600 Specifications

General

Tcase	72.4 °C
Bus type	FSB
Stepping	E0
Processor cache	6 MB
Processor cores	2
Processor model	E8400
System bus rate	- GT/s
Processor family	Intel® Core™2 Duo
Processor series	Intel Core 2 Duo E8000 Series
Processor socket	LGA 775 (Socket T)
Processor codename	Wolfdale
Processing Die size	107 mm²
Processor frequency	3 GHz
Processor cache type	L2
Processor lithography	45 nm
Processor manufacturer	Intel
Processor front side bus	1333 MHz
Processor operating modes	64-bit
ECC supported by processor	No
Thermal Design Power (TDP)	65 W
Number of processors installed	1
CPU multiplier (bus/core ratio)	9
Number of Processing Die Transistors	410 M
Audio system	High Definition Audio
Product type	Workstation
Motherboard chipset	Intel® X38 Express
ECC	Yes
Internal memory	2 GB
Memory clock speed	800 MHz
Internal memory type	DDR2-SDRAM
Maximum internal memory	8 GB
Memory layout (slots x size)	2 x 1 GB
HDD speed	7200 RPM
HDD capacity	250 GB
HDD interface	SATA
Optical drive type	DVD-RW
Graphics card	-
Networking features	Gigabit Ethernet (10/100/1000)
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power supply	475 W
Chassis type	Tower
Country of origin	China
Processor code	SLB9J
Processor ARK ID	33910
Processor package size	37.5 x 37.5 mm
On-board graphics card model	Not available

Weight and Dimensions

Depth	456 mm
Width	168 mm
Height	450 mm
Weight	19000 g