3. Align the triangle on the top of the processor with the triangle on the corner of the processor socket,
and then install the processor into the socket. Ensure that the underside of the processor is level
with the top of the processor socket. Close the socket cover and lightly press down on processor
while closing the socket lever.
Figure 4-62 Seating the processor
System board
This section describes removing and installing the system board.
Removing the system board
To remove the system board:
1. Disconnect power from the system (
Predisassembly procedures on page 58) and remove the side
access panel (
Removing the side access panel on page 64).
NOTE: Although the processor heatsink can remain in place, you might want to remove it for
convenience.
2. Remove all expansion boards and graphics cards (Removing a PCI Express card on page 81,
Removing a PCI card on page 83), and then remove the processor heatsink (Removing the
processor heatsink on page 103).
TIP: Make a note of the cable connections before disconnecting them from the system board.
For more information, refer to
Power connections to drives on page 89 .
3. Disconnect all cabling from the system board.
ENWW Removing and replacing components 107
To Next Page
Loading...
