Using the Computer Setup (F10) Utility to Reset CMOS
1. Access the Computer Setup (F10) Utility menu. When the Computer Setup message appears in
the lower-right corner of the screen, press F10. Press Enter to bypass the title screen, if necessary.
NOTE: If you do not press the F10 key while the message is displayed, the workstation must be
powered off, then on again, to access the utility.
2. From the Computer Setup (F10) Utility menu, select File>Set Defaults, and then select Exit. This
restores the settings that include boot sequence order and other factory settings. However, it does
not force hardware rediscovery.
NOTE: The workstation passwords and any special configuration information, including the
system date and time, must be reset.
ENWW Clearing and Resetting the CMOS 151
To Next Page
Loading...
